M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Uživatelský manuál stáhnout pdf (Strana 28)

into Standby mode, or re-enters Pro Tools mode automatically if Pro Tools software is

still running.

In the Standalone mode, the Digi 002 has dedicated, in-line, three-band EQ on input

channels 1–8 and dedicated, in-line compressors on input channels 1–4. There are four

sends available on each channel for adding internal Delay or Reverb effects, or for

hooking up external effects processors. Sends 1–2 are dedicated to the internal Delay and

Reverb effects. Sends 3–4 route the input signals out through outputs 7–8 on the back

panel so you can send to external effects.

The 10 “Scribble Strips” display the pan, volume and effects controls, send levels, and

track names. The LED Encoder rings on each channel strip show the pan positions in Pan

View and Master Fader View but show send levels or other information in other views. If

you press the button marked “L R Meter,” then this puts the Digi 002 into Meter mode so

that the LED rings act as postfader meters, unless you are viewing the compressor

controls, in which case they act as input, output, and gain reduction meters for the

displayed compressor.

Hooking up External Sources to the Digi 002 in the Standalone Mode

Inputs 1–4 accept microphone-, line-, or instrument-level signals, and you can adjust the

input gains for these using the controls located at the left of the Digi 002’s top panel.

Inputs 5–8 only accept line-level signals and are switchable between –10 dBV and

+4 dBu using the operating level switches on the Digi 002 back panel.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 70 71

Žádné komentáře

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Uživatelský manuál Strana 28